Difference between revisions of "Krooz"
| Line 45: | Line 45: | ||
The software will soon be available from the [https://github.com/softsr/paparazzi repo] | The software will soon be available from the [https://github.com/softsr/paparazzi repo] | ||
== Bootloader == | == Bootloader == | ||
"Krooz" uses an own | "Krooz" uses an own KroozDFU bootloader (based on [https://github.com/libopencm3/libopencm3 libopencm3] project). | ||
You can find it [https://github.com/softsr/libopencm3/tree/master/examples/stm32/f4/krooz/usb_dfu here], clone to your PC an build or use a precompiled [https://github.com/softsr/libopencm3/downloads binary file] to upload. However the Krooz board is shipped with the KroozDFU bootloader by default. | You can find it [https://github.com/softsr/libopencm3/tree/master/examples/stm32/f4/krooz/usb_dfu here], clone to your PC an build or use a precompiled [https://github.com/softsr/libopencm3/downloads binary file] to upload. However the Krooz board is shipped with the KroozDFU bootloader by default. | ||
Revision as of 14:03, 5 December 2012
Overview
Krooz autopilot board is an all in one rotorcraft solution, with a wide variety of sensors, modules and units on one board in market usual Rotorcraft size.
Features
Krooz is based on the 64 pins STM32F405RGT6 Cortex M4 168MHz processor featuring a Floating point unit (FPU), up to 192k of RAM and 1024k of FLASH.
- STM32 microcontroller STM32F405RGT6 datasheet with 1024kB flash and up to 192kB RAM
- MPU6050 Gyro/Accelerometer sensor
- MRF24WB0 WiFi or BTM-222 Bluetooth (wire or external antenna connector) module on board.
- MS5611Pressure sensor
- MAX7456 OSD module
- 7 x Analog input channels
- 4 x 3.3V TTL UART (5V tolerant)
- 11 x Servo PPM outputs (or 10 if using PPM output receiver)
- 1 x I2C 5V bus
- 1 x Micro USB
- Extra camera control connector
- 3 x status LEDs with attached test point
- Up to 35V (8S LiPo) input power control unit
- ~50mm x ~50mm x ~10mm
- 2 layers PCB design
So, except for a GPS unit with the Krooz you have all necessary sensors for full features all in one rotorcraft solution.
Usage scenarios
Krooz can be used in different telemetry versions:
- with the on-board MRF24WB0 WiFi module
- with the on-board BTM-222 Bluetooth module
- or without any on-board telemetry solution, with a possibility to connect other telemetry link over one of the UART connectors.
Hardware design
Pinout
Programming
Getting started
The software will soon be available from the repo
Bootloader
"Krooz" uses an own KroozDFU bootloader (based on libopencm3 project). You can find it here, clone to your PC an build or use a precompiled binary file to upload. However the Krooz board is shipped with the KroozDFU bootloader by default.
Source code
The Krooz source code is based on Paparazzi master git branch, and ported on the STM32F4 Cortex™-M4 processor family. It is available from here