Difference between revisions of "Lia"
Jump to navigation
Jump to search
(re-added differing default jumper config) |
|||
| (2 intermediate revisions by 2 users not shown) | |||
| Line 3: | Line 3: | ||
== Differences from Lisa/M == | == Differences from Lisa/M == | ||
* 0.1" pitch | * 0.1" pitch through-holes instead of molex picoblade | ||
* No CAN transceiver (footprint still present just not populated) | * No CAN transceiver (footprint still present just not populated) on [http://www.transition-robotics.com Transition Robotics]serial numbers LI1-001 through LI1-200 (populated on serial numbers ≥LI1-201) | ||
* No I2C2 level shifter (footprint still present just not populated) | * No I2C2 level shifter (footprint still present just not populated) | ||
* No 5V voltage regulator (footprint still present just not populated) | * No 5V voltage regulator (footprint still present just not populated) | ||
| Line 33: | Line 33: | ||
|} | |} | ||
'''WARNING: DO NOT CLOSE BOTH JP8 AND JP9 SIMULTANEOUSLY!!!''' | '''WARNING: DO NOT CLOSE BOTH JP8 AND JP9 SIMULTANEOUSLY!!!''' | ||
[[Category:Lisa]] | |||
Latest revision as of 12:32, 21 November 2013
Lia is a lower cost version of Lisa/M first developed for inclusion with the Quadshot Mocha.
Differences from Lisa/M
- 0.1" pitch through-holes instead of molex picoblade
- No CAN transceiver (footprint still present just not populated) on Transition Roboticsserial numbers LI1-001 through LI1-200 (populated on serial numbers ≥LI1-201)
- No I2C2 level shifter (footprint still present just not populated)
- No 5V voltage regulator (footprint still present just not populated)
- No JTAG connector (footprint still present just not populated)
- Added servo power inline resistors (by default 0 ohm but can be changed to higher value for balancing the linear voltage regulators of the motor controllers)
Pictures
Lia V1.1 top side
Lia V1.1 bottom side
Lia V1.1 bottom side with Aspirin 2.1 nomag nobaro placed.
Jumper Configuration
There are a number of jumpers on Lia used to configure voltage levels and power input. Their locations and functions are identical to those on the Lisa/M v2.0.
See the Jumper Configuration section on the Lisa/M v2.0 page.
Note that the default states of JP8 and JP9 are reversed with respect to the defaults of Lisa/M v2.0; that is:
| Jumper | Bus Connection | Default | Description |
|---|---|---|---|
| JP8 | UART1&5_VCC to V_IN | CLOSED | Connects UART1 and UART5 connector VCC to autopilot input voltage V_IN rail |
| JP9 | UART1&5_VCC to +3V3 | OPEN | Connects UART1 and UART5 connector VCC to autopilot +3V3 rail |
WARNING: DO NOT CLOSE BOTH JP8 AND JP9 SIMULTANEOUSLY!!!