Difference between revisions of "Lia"

From PaparazziUAV
Jump to: navigation, search
(re-added differing default jumper config)
m (corrected CAN tranciever info)
Line 4: Line 4:
  
 
* 0.1" pitch connectors instead of molex picoblade
 
* 0.1" pitch connectors instead of molex picoblade
* No CAN transceiver (footprint still present just not populated)
+
* No CAN transceiver (footprint still present just not populated) on [http://www.transition-robotics.com Transition Robotics]serial numbers LI1-001 through LI1-200 (populated on serial numbers ≥LI1-201)
 
* No I2C2 level shifter (footprint still present just not populated)
 
* No I2C2 level shifter (footprint still present just not populated)
 
* No 5V voltage regulator (footprint still present just not populated)
 
* No 5V voltage regulator (footprint still present just not populated)

Revision as of 12:02, 25 March 2013

Lia is a lower cost version of Lisa/M first developed for inclusion with the Quadshot Mocha.

Differences from Lisa/M

  • 0.1" pitch connectors instead of molex picoblade
  • No CAN transceiver (footprint still present just not populated) on Transition Roboticsserial numbers LI1-001 through LI1-200 (populated on serial numbers ≥LI1-201)
  • No I2C2 level shifter (footprint still present just not populated)
  • No 5V voltage regulator (footprint still present just not populated)
  • No JTAG connector (footprint still present just not populated)
  • Added servo power inline resistors (by default 0 ohm but can be changed to higher value for balancing the linear voltage regulators of the motor controllers)

Pictures

Jumper Configuration

There are a number of jumpers on Lia used to configure voltage levels and power input. Their locations and functions are identical to those on the Lisa/M v2.0.
See the Jumper Configuration section on the Lisa/M v2.0 page.

Note that the default states of JP8 and JP9 are reversed with respect to the defaults of Lisa/M v2.0; that is:

Lia UART1 and UART5 VCC Configuration
Jumper Bus Connection Default Description
JP8 UART1&5_VCC to V_IN CLOSED Connects UART1 and UART5 connector VCC to autopilot input voltage V_IN rail
JP9 UART1&5_VCC to +3V3 OPEN Connects UART1 and UART5 connector VCC to autopilot +3V3 rail

WARNING: DO NOT CLOSE BOTH JP8 AND JP9 SIMULTANEOUSLY!!!