Difference between revisions of "Booz/HardwareTest"
Jump to navigation
Jump to search
m (moved BoozHardwareTest to Booz/HardwareTest: wiki reorg) |
|||
| (2 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
<categorytree style="float:right; clear:right; margin-left:1ex; border: 1px solid gray; padding: 0.7ex;" mode=pages>Booz</categorytree> | |||
__TOC__ | |||
The ''Makefile'' for those is in ''conf/autopilot/booz2_test_progs.makefile'' | The ''Makefile'' for those is in ''conf/autopilot/booz2_test_progs.makefile'' | ||
| Line 44: | Line 47: | ||
make AIRCRAFT=BOOZ2_A1 test_max1168.upload | make AIRCRAFT=BOOZ2_A1 test_max1168.upload | ||
[[Category:User_Documentation]] [[Category:Hardware]] [[Category:Software]] [[Category:Booz]] | |||
Latest revision as of 16:51, 4 March 2012
The Makefile for those is in conf/autopilot/booz2_test_progs.makefile
test_downlink
Paparazzi's Makefile allow you to build different TARGETS (aka programs) using a doted notation. The begining of the Makefile reads
#
# test downlink
#
test_downlink.ARCHDIR = $(ARCHI)
test_downlink.ARCH = arm7tdmi
test_downlink.TARGET = test_downlink
test_downlink.TARGETDIR = test_downlink
#
test_downlink.CFLAGS += -DBOARD_CONFIG=$(BOARD_CFG) $(BOOZ_CFLAGS)
test_downlink.CFLAGS += -DPERIPHERALS_AUTO_INIT
test_downlink.srcs += $(SRC_BOOZ_TEST)/booz2_test_downlink.c
test_downlink.CFLAGS += -DUSE_LED
test_downlink.CFLAGS += -DPERIODIC_TASK_PERIOD='SYS_TICS_OF_SEC((1./10.))' -DTIME_LED=1
test_downlink.srcs += sys_time.c $(SRC_ARCH)/sys_time_hw.c $(SRC_ARCH)/armVIC.c
#
test_downlink.CFLAGS += -DUSE_UART1 -DUART1_BAUD=B57600
test_downlink.srcs += $(SRC_ARCH)/uart_hw.c
#
test_downlink.CFLAGS += -DDOWNLINK -DDOWNLINK_TRANSPORT=PprzTransport -DDOWNLINK_DEVICE=Uart1
test_downlink.srcs += downlink.c pprz_transport.c
FIXME: More on this when syntax highlighting/line numbering works
The command line to compile the "test_downlink" target for the BOOZ2_A1 aircraft would be
make AIRCRAFT=BOOZ2_A1 test_downlink.compile
and to upload this program to your board ( you don't really need to type the previous command, make is smart and will compile your program if needed when you ask him to upload it )
make AIRCRAFT=BOOZ2_A1 test_downlink.upload
test_max1168
the max1168 is the 16 bits analog to digital converter chip used on the IMU to sample gyros and accels.
make AIRCRAFT=BOOZ2_A1 test_max1168.upload