Tiny GPS config

Prerequisites:

1. Must have loaded USB Boot Loader software
2. Must have loaded "tunnel"
3. Must have downloaded and installed u-center
4. Must have downloaded, uncompressed the LEA-4P config file

Required Cables:

1. FTDI Serial Adapter Cable
2. 8-pin Molex Picoblade connector to 6-pin FTDI cable

Steps:

1. Connect FTDI cable + 8-pin Molex adapter to USB on your laptop
2. Connect 8-pin Molex to "serial1" on Tiny2.11
3. Power on Tiny2.11
4. Start u-center application
5. set connection speed to 9600BPS (LEA-4P factory default)
6. Menu: Tools/GPS Config select the file to upload (LEA-4P file downloaded)
7. Click File >> GPS button to send the file to the GPS
8. About 2/3 the way through it will stop. At this point change 'baudrate' to 38,4000 connection and it will continue and finish

BACK