Tiny GPS config

Prerequisites:

1. Must have loaded USB Boot Loader software
2. Must have loaded "tunnel"

Required Cables:

1. FTDI Serial Adapter Cable
2. 8-pin Molex Picoblade connector to 6-pin FTDI cable

Steps:

1. Connect FTDI cable + 8-pin Molex adapter to USB on your laptop
2. Connect 8-pin Molex to "serial1" on Tiny2.11
3. Using "Jumper" set P0.14 "low" and keep it held low
4. Power on Tiny2.11
5. Enter this command in a terminal: make upload_bl PROC=GENERIC

BACK