Tiny GPS config

From PaparazziUAV
Revision as of 19:27, 20 April 2008 by Dconger (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Prerequisites:

  1. Must have loaded USB Boot Loader software
  2. Must have loaded "tunnel"

Required Cables:

  1. FTDI Serial Adapter Cable
  2. 8-pin Molex Picoblade connector to 6-pin FTDI cable

Steps:

  1. Connect FTDI cable + 8-pin Molex adapter to USB on your laptop
  2. Connect 8-pin Molex to "serial1" on Tiny2.11
  3. Using "Jumper" set P0.14 "low" and keep it held low
  4. Power on Tiny2.11
  5. Enter this command in a terminal: make upload_bl PROC=GENERIC