ImuCalibration/Gyroscopes
Jump to navigation
Jump to search
Turntable Procedure
Hardware
Pictures
Turntable rig
IMU cradle view 1.0
IMU cradle view 1.1
Encoder mount base
Olimex LPC H2148
Omron rotary encoder
Components
- audio-technica AT-LP120_USB Direct Drive Professional Turntable
- Olimex LPC H2148
- Omron rotary encoder
- Lisa/L+IMU, Xbee 2.4Ghz modem set, fibreglass mounting plates and general wiring components
Wiring
Encoder to LPC
- Black (common) to EXT2 GND
- Red 5~12 VDC to EXT2 Vin(5v)
- White OUTA to EXT1 PO.22
LPC to LPC
- EXT2 3.3v to EXT1 PO.22 (pull up resistor)
Software
LPC Code Modifications
In case of USB 2.0 A-B cable operation, ~/conf/airframes/Poine/turntable.xml has to be amended, as follows, and saved as ~/turntable_dev_usb.xml:
| File: conf/airframes/Poine/turntable_dev_usb.xml |
main.CFLAGS += -DUSE_USB_SERIAL
main.srcs += $(SRC_ARCH)/usb_ser_hw.c
main.srcs += $(SRC_ARCH)/lpcusb/usbhw_lpc.c $(SRC_ARCH)/lpcusb/usbinit.c
main.srcs += $(SRC_ARCH)/lpcusb/usbcontrol.c $(SRC_ARCH)/lpcusb/usbstdreq.c
main.CFLAGS += -DDOWNLINK -DDOWNLINK_TRANSPORT=PprzTransport -DDOWNLINK_DEVICE=UsbS
#main.CFLAGS += -DUSE_UART0 -DUART0_BAUD=B115200
#main.srcs += mcu_periph/uart.c
#main.srcs += $(SRC_ARCH)/mcu_periph/uart_arch.c
#main.CFLAGS += -DDOWNLINK -DDOWNLINK_TRANSPORT=PprzTransport -DDOWNLINK_DEVICE=Uart0
main.srcs += subsystems/datalink/downlink.c subsystems/datalink/pprz_transport.c
#main.CFLAGS += -DMB_TACHO
#main.srcs += $(MB)/mb_tacho.c
</makefile>
</airframe>
|
A new turntable session has to be added to ~/conf/control_panel.xml:
| File: conf/control_panel.xml |
<session name="Flight with USB-serial_TT modem">
<program name="Data Link">
<arg flag="-d" constant="/dev/ttyACM0"/>
<arg flag="-nouplink" constant=""/>
<arg flag="-s" constant="115200"/>
</program>
<program name="Server"/>
<program name="GCS"/>
</session>
|