Difference between revisions of "Talk:Lisa/Bone"
Jump to navigation
Jump to search
| Line 8: | Line 8: | ||
Note from Bryan: | Note from Bryan: | ||
The SPI bus on the BB only can act as master. This would make the BB have to do busy loops polling the autopilot to check for data. I propose CAN as it has error detection and data framing. | *The SPI bus on the BB only can act as master. This would make the BB have to do busy loops polling the autopilot to check for data. I propose CAN as it has error detection and data framing. | ||
*The lithium battery system only can act as a charger. The BB's power supply will not let it run on the nominal 3.6v of the lithium cell without a boosting SMPS. | |||
Revision as of 12:16, 14 April 2014
JKG Questions:
- Do we need a power supply on the cape? It will increase cost quite a bit. If Lisa/M is still connected directly to peripherals it may as well get power from off-board, most vehicles already have a 5-6V servo bus
- fully-populated Lia vs Lisa/M?
- Allows (almost) all connections to be broken out through the cape and BBB -- 0.1" header pins on Lia and sockets on cape with screws to lock boards together
- much less wire nest
- no header pin access to ANALOG1 or ANALOG2
- Allows (almost) all connections to be broken out through the cape and BBB -- 0.1" header pins on Lia and sockets on cape with screws to lock boards together
Note from Bryan:
- The SPI bus on the BB only can act as master. This would make the BB have to do busy loops polling the autopilot to check for data. I propose CAN as it has error detection and data framing.
- The lithium battery system only can act as a charger. The BB's power supply will not let it run on the nominal 3.6v of the lithium cell without a boosting SMPS.