Difference between revisions of "STLink"
(update) |
|||
| Line 16: | Line 16: | ||
==SWD Header== | ==SWD Header== | ||
[[Image:SWD_Discovery_to_Apogee.png|Pinout with Apogee connector]] | |||
==Install Software== | ==Install Software== | ||
Revision as of 14:36, 10 January 2014
SWD is a program und debug protocoll for ARM processors.
Every STM discovery board comes with a ST-LinkV2 on board (except STM32VL comes with ST-LinkV1).
Every dicovery board from STM comes wih a ST-LinkV2, except STM32VL (ST-LinkV1).
SWD Header
Install Software
st-flash and st-util are needed Tools from texane
download and compile
git clone git://github.com/texane/stlink.git stlink cd stlink ./autogen.sh ./configure make
copy the two tools into bin directory
sudo cp st-flash /usr/bin sudo cp st-util /usr/bin
add udev rules (replace user with your username)
sudo cp /home/user/stlink/49-stlinkv*.rules /etc/udev/rules.d sudo udevadm control --reload-rules
ST-LinkV1 requires a bit different treatment, read the Readme.txt
Airframe.xml setup
Connect the ST-Link to the MCU. If a complete STM32F-Discovery board is used, CN3 jumpers need to be set. To program a external MCU, remove CN3 jumpers and connect the external MCU with the SWD header.
To use SWD
Set FLASH_MODE=SWD
To use stlink (requires line above)
Set STLINK=y
Update the ST-Link to blackmagic probe
The STM32F103 (STLink MCU) can be flashed with the blackmagic's firware.
This is irveversable !
How to upload the blackmagic probe firmware to the STLink of a discovery board