Difference between revisions of "Tiny GPS config"
Jump to navigation
Jump to search
| Line 9: | Line 9: | ||
<ol> | <ol> | ||
<li>[[Image:Ftdicbl.jpg|32px]]FTDI Serial Adapter Cable | <li>[[Image:Ftdicbl.jpg|32px]]FTDI Serial Adapter Cable | ||
<li>[[Image: | <li>[[Image:Gpscbl1.jpg|32px]]8-pin Molex Picoblade connector to 6-pin FTDI cable | ||
</ol> | </ol> | ||
Steps: | Steps: | ||
<ol> | <ol> | ||
<li>Connect FTDI | <li>Connect FTDI Cable + 8-pin Molex adapter to USB on your laptop | ||
<li>Connect 8-pin Molex to "serial1" on Tiny2.11 | <li>Connect 8-pin Molex to "serial1" on Tiny2.11 | ||
<li>Power on Tiny2.11 | <li>Power on Tiny2.11 | ||
Revision as of 19:45, 20 April 2008
Prerequisites:
- Must have loaded USB Boot Loader software
- Must have loaded "tunnel"
- Must have downloaded and installed u-center
- Must have downloaded, uncompressed the LEA-4P config file
Required Cables:
FTDI Serial Adapter Cable
8-pin Molex Picoblade connector to 6-pin FTDI cable
Steps:
- Connect FTDI Cable + 8-pin Molex adapter to USB on your laptop
- Connect 8-pin Molex to "serial1" on Tiny2.11
- Power on Tiny2.11
- Start u-center application
- set connection 'baudrate' to 9600BPS (LEA-4P factory default)
- Menu: Tools/GPS Config select the file to upload (LEA-4P file downloaded)
- Click File >> GPS button to send the file to the GPS
- About 2/3 the way through it will stop. At this point change 'baudrate' to 38,4000 connection and it will continue and finish