Difference between revisions of "Tiny GPS config"
Jump to navigation
Jump to search
| Line 17: | Line 17: | ||
<li>Power on Tiny2.11 | <li>Power on Tiny2.11 | ||
<li>Start u-center application | <li>Start u-center application | ||
<li>set connection | <li>set connection 'baudrate' to 9600BPS (LEA-4P factory default) | ||
<li>Menu: Tools/GPS Config select the file to upload (LEA-4P file downloaded) | <li>Menu: Tools/GPS Config select the file to upload (LEA-4P file downloaded) | ||
<li>Click File >> GPS button to send the file to the GPS | <li>Click File >> GPS button to send the file to the GPS | ||
Revision as of 18:42, 20 April 2008
Prerequisites:
- Must have loaded USB Boot Loader software
- Must have loaded "tunnel"
- Must have downloaded and installed u-center
- Must have downloaded, uncompressed the LEA-4P config file
Required Cables:
- FTDI Serial Adapter Cable
- 8-pin Molex Picoblade connector to 6-pin FTDI cable
Steps:
- Connect FTDI cable + 8-pin Molex adapter to USB on your laptop
- Connect 8-pin Molex to "serial1" on Tiny2.11
- Power on Tiny2.11
- Start u-center application
- set connection 'baudrate' to 9600BPS (LEA-4P factory default)
- Menu: Tools/GPS Config select the file to upload (LEA-4P file downloaded)
- Click File >> GPS button to send the file to the GPS
- About 2/3 the way through it will stop. At this point change 'baudrate' to 38,4000 connection and it will continue and finish