Difference between revisions of "STLink"
(→Install Software: edited directory for stlink tools from user folder to /opt) |
|||
| Line 20: | Line 20: | ||
==Install Software== | ==Install Software== | ||
For Ubuntu/Debian. <br/> | |||
st-flash and st-util are needed [https://github.com/texane/stlink Tools from texane] | st-flash and st-util are needed [https://github.com/texane/stlink Tools from texane] | ||
Download and compile | |||
cd | |||
git clone git://github.com/texane/stlink.git stlink | git clone git://github.com/texane/stlink.git stlink | ||
sudo mv stlink /opt | |||
cd stlink | cd stlink | ||
./autogen.sh | ./autogen.sh | ||
| Line 29: | Line 32: | ||
make | make | ||
Set enviroment variables | |||
exportline="PATH=$PATH:/opt/stlink" | |||
if grep -Fxq "$exportline" ~/.profile; then echo nothing to do ; else echo $exportline >> ~/.profile; fi | |||
source ~/.profile | |||
Add udev rules (replace user with your username) | |||
sudo cp / | sudo cp /opt/stlink/49-stlinkv*.rules /etc/udev/rules.d | ||
sudo udevadm control --reload-rules | sudo udevadm control --reload-rules | ||
ST-LinkV1 requires a bit different treatment, read the [https://github.com/texane/stlink/blob/master/README Readme.txt] | ST-LinkV1 requires a bit different treatment, read the [https://github.com/texane/stlink/blob/master/README Readme.txt] | ||
==Airframe.xml setup== | ==Airframe.xml setup== | ||
Revision as of 14:59, 5 March 2014
SWD is a program und debug protocoll for ARM processors.
Every STM discovery board comes with a ST-LinkV2 on board (except STM32VL comes with ST-LinkV1).
Every dicovery board from STM comes wih a ST-LinkV2, except STM32VL (ST-LinkV1).
SWD Header
Install Software
For Ubuntu/Debian.
st-flash and st-util are needed Tools from texane
Download and compile
cd git clone git://github.com/texane/stlink.git stlink sudo mv stlink /opt cd stlink ./autogen.sh ./configure make
Set enviroment variables
exportline="PATH=$PATH:/opt/stlink" if grep -Fxq "$exportline" ~/.profile; then echo nothing to do ; else echo $exportline >> ~/.profile; fi source ~/.profile
Add udev rules (replace user with your username)
sudo cp /opt/stlink/49-stlinkv*.rules /etc/udev/rules.d sudo udevadm control --reload-rules
ST-LinkV1 requires a bit different treatment, read the Readme.txt
Airframe.xml setup
Connect the ST-Link to the MCU. If a complete STM32F-Discovery board is used, CN3 jumpers need to be set. To program a external MCU, remove CN3 jumpers and connect the external MCU with the SWD header.
To use STLink via SWD
Set FLASH_MODE=STLINK
Update the ST-Link to blackmagic probe
The STM32F103 (STLink MCU) can be flashed with the blackmagic's firware.
This is irveversable !
How to upload the blackmagic probe firmware to the STLink of a discovery board