Difference between revisions of "STLink"
Jump to navigation
Jump to search
(add to FirmwareFlashing category) |
|||
| Line 7: | Line 7: | ||
[[Image:St-link.jpg|thumb|right|ST-Link (stm32f4-Discovery)]] | [[Image:St-link.jpg|thumb|right|ST-Link (stm32f4-Discovery)]] | ||
[http://www.arm.com/products/system-ip/debug-trace/coresight-soc-components/serial-wire-debug.php SWD] can be used to upload the firmware to | [http://www.arm.com/products/system-ip/debug-trace/coresight-soc-components/serial-wire-debug.php SWD] can be used to upload the firmware to stm32fx MCU without a bootloader. | ||
A ST-Link is needed, any stm32-discovery board has one on it (starts @ 8€). | A ST-Link is needed, any stm32-discovery board has one on it (starts @ 8€). | ||
Revision as of 07:53, 3 September 2013
SWD can be used to upload the firmware to stm32fx MCU without a bootloader.
A ST-Link is needed, any stm32-discovery board has one on it (starts @ 8€).
A standard ST-Link costs from 17€
Needed Tools
st_flash and st_util need to be installed, compiled from source (https://github.com/texane/stlink)
Howto
Connect the ST-Link to the MCU. If a complete stm32fx-discovery board is used, CN3 jumpers need to be set. To program a external MCU, remove CN3 jumpers and connect the external MCU with the SWD header.