Difference between revisions of "User/LisaM"

From PaparazziUAV
Jump to navigation Jump to search
m (User/LisaM moved to LisaM: Clean up of documentation pages)
m (redirect to correct page right away)
 
(71 intermediate revisions by 6 users not shown)
Line 1: Line 1:
[[Image:Lisa_M_V1_0_top_with_coin.jpg|thumb|Lisa/M V1.0 top view]]
#REDIRECT [[Lisa/M v2.0]]
[[Image:Lisa_M_V1_0_bottom_with_coin.jpg|thumb|Lisa/M V1.0 bottom view]]
[[Image:Lisa_M_V1_0_top.jpg|thumb|Lisa/M V1.0 top view]]
[[Image:Lisa_M_V1_0_bottom.jpg|thumb|Lisa/M V1.0 bottom view]]
== General description ==
 
== Mechanical drawing ==
[[Image:LisaM_V1_0_top_mechanical.png|500px]]
 
== Connector legend ==
[[Image:LisaM_V1_0_top_labeled.png|700px]]
 
== Satellite 2.4 GHZ Receiver connection ==
[[Image:Lisa_M_V1_0_satellite_receiver_connection_labeled.png|500px]]
 
== Power supply jumpers ==
[[Image:LisaM_V1_0_top_jumpers_and_leds.png|500px]][[Image:LisaM_V1_0_bottom_jumpers.png|450px]]
 
It is possible to reconfigure the electrical system on Lisa/M using the supply jumpers.
 
* JP1 connects the servo power rail to V_IN rail.
* JP2 connects the battery rail (used by default only for battery voltage measurement) to the V_IN rail.
* JP3 bypasses the +5V voltage regulator and connects V_IN to the +5V rail.
* JP4 connects the +5V rail to the VCC pin on the UART2 connector.
* JP5 connects the +3V3 rail to the VCC pin on the UART2 connector.
* JP6 connects the +5V rail to the VCC pin on the UART1 connector.
* JP7 connects the +3V3 rail to the VCC pin on the UART1 connector.
 
[[Category:User_Documentation]] [[Category:Hardware]]

Latest revision as of 07:46, 16 December 2012

Redirect to:

Retrieved from "http://wiki.paparazziuav.org/w/index.php?title=User/LisaM&oldid=13884"