Difference between revisions of "User/LisaM"

Latest revision as of 07:46, 16 December 2012

Redirect to:

@@ Line 1: / Line 1: @@
-[[Image:Lisa_M_V1_0_top_with_coin.jpg|thumb|Lisa/M V1.0 top view]]
+#REDIRECT [[Lisa/M v2.0]]
-[[Image:Lisa_M_V1_0_bottom_with_coin.jpg|thumb|Lisa/M V1.0 bottom view]]
-[[Image:Lisa_M_V1_0_top.jpg|thumb|Lisa/M V1.0 top view]]
-[[Image:Lisa_M_V1_0_bottom.jpg|thumb|Lisa/M V1.0 bottom view]]
-== General description ==
-== Mechanical drawing ==
-[[Image:LisaM_V1_0_top_mechanical.png|500px]]
-== Connector legend ==
-[[Image:LisaM_V1_0_top_labeled.png|700px]]
-== Satellite Receiver connection ==
-[[Image:Lisa_M_V1_0_satellite_receiver_connection_labeled.png|500px]]
-== Power supply jumpers ==
-[[Image:LisaM_V1_0_top_jumpers_and_leds.png|500px]][[Image:LisaM_V1_0_bottom_jumpers.png|450px]]
-It is possible to reconfigure the electrical system on Lisa/M using the supply jumpers.
-* JP1 connects the servo power rail to V_IN rail.
-* JP2 connects the battery rail (used by default only for battery voltage measurement) to the V_IN rail.
-* JP3 bypasses the +5V voltage regulator and connects V_IN to the +5V rail.
-* JP4 connects the +5V rail to the VCC pin on the UART2 connector.
-* JP5 connects the +3V3 rail to the VCC pin on the UART2 connector.
-* JP6 connects the +5V rail to the VCC pin on the UART1 connector.
-* JP7 connects the +3V3 rail to the VCC pin on the UART1 connector.
-[[Category:User_Documentation]] [[Category:Hardware]]