Difference between revisions of "SDLogger SPI Direct"
Jump to navigation
Jump to search
BartSlinger (talk | contribs) m |
m |
||
| Line 15: | Line 15: | ||
[[File:LisaSDback.jpeg|frame|x300px|left|Lisa/SD module with Deltang R31d]] | [[File:LisaSDback.jpeg|frame|x300px|left|Lisa/SD module with Deltang R31d]] | ||
[[Category:Modules]] | |||
Revision as of 07:46, 16 November 2015
The direct SPI SD Logger is originally designed to be used with the Lisa/S, but should also be compatible with other supported autopilots. It connects directly to the SPI bus of the autopilot and communicates using the SDCards SPI interface. This method is slower than when using it in SD mode, but the speed is sufficient to log IMU data at 512 Hz.
Installation
The SD Card needs to be connected to the SPI bus of the autopilot. The pinout for an SD Card is shown in the figure.
- VSS = Ground
- VDD = 3.3V
Lisa/SD
A SuperbitRF-sized PCB connects the SD card to the Lisa/S. Additionally, this PCB has pads to connect a Deltang R31d RC receiver and a molex connector for general purpose.
Lisa/SD module with Deltang R31d