Lisa

Lisa ( the Lost Illusions Serendipitous Autopilot) is a STM32/Overo board designed to run Paparazzi

TODO

• Generic
  • JTAG on STM32: ok
  • I2C on STM32:
  • SPI on STM32:
  • Pressure sensors:
  • USB for gumstix : does 5V need to be switchable ? (to allow reset from the gumstix)
  • Make sure STM32 can interrupt overo

• Antoine:
  • Take todo's from above associate to names
  • Todo's from sheet 3
  • Check's from sheet 5
  • Pressure sensor instruction to gany (redo airspeed computation), so he can finish the schematic for that (or finish it directly in the schematic)
  • work with piotr on connecting the missing wires on the STM

• Esden:
  • STM32 spelling and connection check
  • Fix STM32 footprint pad sizes
  • howto for STM32 gcc gdb toolchain (blinking LED or similar)
  • Routing rules that have to be observed

• Gany:
  • Check FT2232 footprint hw/lbr/booz.lbr qfn-64 size & pinbelegung
  • Place components
  • Route board
  • Send for production 4pcb/pcbcard(china)/sunstone

Hardware

The hardware is still in development. The current CAD files are maintained in savannah svn in the paparazzi4/trunk/hw/lisa directory. Software development is done on a Overo/Summit + Olimex STM32-H103 dev board

Software

STM32 toolchain

You can use the summon-arm-toolchain script to build the required toolchain. For the default values of the Paparazzi Makefile to work, you should set

PREFIX=/opt/stm32/toolchain/arm-elf and LIBSTM32_EN=1

Open Embedded

Open Embedded is the linux distribution used on the overo. You can follow the instructions on gumstix's website to build a complete cross development environment. Paparazzi's Makefile will default to look for it in /overo-oe