Difference between revisions of "Twoglogdedicated"
Jump to navigation
Jump to search
(Created page with "=Introduction= A TWOG board dedicated for Logging") |
|||
| Line 1: | Line 1: | ||
=Introduction= | =Introduction= | ||
A TWOG board dedicated for | A TWOG board dedicated for LoggingYou can directly connect a micro SD card to a TWOG. Remember that micro SD cards do have a limited number of insertions and should not be plugged too often. The (micro) SD card is connected to the SPI1 of the TWOG following this scheme: | ||
[[Image:sd_spi.jpg|thumb|micro SD card connected to SPI]] | |||
microSD TinyV2 SPI J3 | |||
8 nc | |||
7 DO 5 MISO | |||
6 GND 1 GND | |||
5 CLK 7 SCK | |||
4 Vcc 2 +3V3 | |||
3 DI 4 MOSI | |||
2 CS 3 SSEL | |||
1 nc | |||
Looking onto the gold plated connector side of the microSD card: | |||
############### | |||
I 8 | |||
I 7 | |||
I 6 | |||
I 5 | |||
I 4 | |||
I 3 | |||
I 2 | |||
I 1 | |||
###### ## | |||
\ I \ | |||
## ## | |||
The start/stop button is connected to the BUTTON (P0.7) pin of the USB connector (J9). It is activated by pulling it low. | |||
Latest revision as of 08:17, 19 November 2015
Introduction
A TWOG board dedicated for LoggingYou can directly connect a micro SD card to a TWOG. Remember that micro SD cards do have a limited number of insertions and should not be plugged too often. The (micro) SD card is connected to the SPI1 of the TWOG following this scheme:
microSD TinyV2 SPI J3 8 nc 7 DO 5 MISO 6 GND 1 GND 5 CLK 7 SCK 4 Vcc 2 +3V3 3 DI 4 MOSI 2 CS 3 SSEL 1 nc
Looking onto the gold plated connector side of the microSD card:
###############
I 8
I 7
I 6
I 5
I 4
I 3
I 2
I 1
###### ##
\ I \
## ##
The start/stop button is connected to the BUTTON (P0.7) pin of the USB connector (J9). It is activated by pulling it low.