Difference between revisions of "STLink"

From PaparazziUAV
Jump to: navigation, search
(Update the ST-Link to blackmagic probe)
Line 11: Line 11:
 
[http://www.arm.com/products/system-ip/debug-trace/coresight-soc-components/serial-wire-debug.php Serial Wire Debug (SWD)] is a program and debug protocol for ARM processors. It's a low pin count and high-performance alternative to JTAG
 
[http://www.arm.com/products/system-ip/debug-trace/coresight-soc-components/serial-wire-debug.php Serial Wire Debug (SWD)] is a program and debug protocol for ARM processors. It's a low pin count and high-performance alternative to JTAG
  
Every STM discovery board comes with a [http://www.st.com/web/catalog/tools/FM146/CL1984/SC724/SS1677/PF251168 ST-Link V2] on board, with one exception; the STM32VL version, that board comes with ST-Link V1.
+
Every STM discovery / eval board comes with a [http://www.st.com/web/catalog/tools/FM146/CL1984/SC724/SS1677/PF251168 ST-Link V2] on board, with one exception; the STM32VL version, that board comes with ST-Link V1.
  
 
==SWD Header==
 
==SWD Header==

Revision as of 13:28, 30 March 2015

St-link.jpg


Serial Wire Debug (SWD) is a program and debug protocol for ARM processors. It's a low pin count and high-performance alternative to JTAG

Every STM discovery / eval board comes with a ST-Link V2 on board, with one exception; the STM32VL version, that board comes with ST-Link V1.

SWD Header

Pinout with Apogee connector

Install Software

The st-flash and st-util tools are needed, provied by texane

Download and compile

$ cd /opt
$ git clone git://github.com/texane/stlink.git stlink
$ cd stlink
$ ./autogen.sh
$ ./configure
$ make

Set enviroment variable

$ exportline="PATH=$PATH:/opt/stlink"
$ if grep -Fxq "$exportline" ~/.profile; then echo nothing to do ; else echo $exportline >> ~/.profile; fi
$ source ~/.profile

Add udev rules

$ sudo cp /opt/stlink/49-stlinkv*.rules /etc/udev/rules.d
$ sudo udevadm control --reload-rules

ST-LinkV1 requires a bit different treatment, read the Readme.txt

Airframe.xml setup

Connect the ST-Link to the MCU. If a complete STM32Fx-Discovery board is used, CN3 jumpers need to be set. To program a external MCU, remove CN3 jumpers and connect the external MCU with the SWD header.

To use SWD via STLink as default:
Set FLASH_MODE=STLINK

Update the ST-Link to blackmagic probe

The STM32F103 (STLink MCU) can be flashed with the blackmagic's firware.

Black Magic Discovery from Esden <-- This also describes how to remove the read out protection.
embdev.net page