Difference between revisions of "Airspeed sensor"

From PaparazziUAV
Jump to navigation Jump to search
(Redirecting to Sensors/Airspeed)
 
(45 intermediate revisions by 7 users not shown)
Line 1: Line 1:
By default, airspeed is estimated by measuring the GPS ground speed. This gives reasonable results particularly in calm conditions. Airspeed sensors measure actual airspeed resulting in better performance especially in windy conditions.
#REDIRECT [[Sensors/Airspeed]]
 
=Connecting the EagleTree Airspeed Sensor=
 
The module is low cost and comes with a very good pitot tube (Prandtl style, pitot-static tube) that includes static and dynamic ports. The autopilot code has been modified to regulate the throttle in order to keep the airspeed constant (and a minimum ground speed).
 
 
The EagleTree Airspeed sensor is quite easy to connect to the Tiny/TWOG . The sensor has an I2C interface that connects directly to the Tiny/TWOG I2C port. I was able to figure out the slave address and decode the raw output of the sensor. The results are quite good,
First, connect the sensor directly to the TWOG (J6). The sensor module wires are:
Red wire: 5V
White wire: Ground
Yellow wire: SDA
Brown wire: SCL
Then, in the airframe file (near the end of the file), you have to add:
ap.CFLAGS += -DUSE_AIRSPEED_ETS -DUSE_AIRSPEED -DUSE_I2C0 -DAGR_CLIMB
ap.srcs += airspeed.c airspeed_ets.c i2c.c $(SRC_ARCH)/i2c_hw.c
 
At the end of the "VERTICAL CONTROL" section of the airframe file, you have to add:
    <!-- auto airspeed and altitude inner loop (for airspeed sensor) -->
    <define name="AUTO_AIRSPEED_SETPOINT" value="15.0" unit="m/s"/>
    <define name="AUTO_AIRSPEED_PGAIN" value="0.060"/>
    <define name="AUTO_AIRSPEED_IGAIN" value="0.050"/> 
    <define name="AUTO_GROUNDSPEED_SETPOINT" value="6.0" unit="m/s"/>
    <define name="AUTO_GROUNDSPEED_PGAIN" value="0.75"/>
    <define name="AUTO_GROUNDSPEED_IGAIN" value="0.25"/>   
Note that the SETPOINT values may need to be adjusted to suit your airframe.
See paparazzi3/conf/airframes/easystar2.xml for an example airframe configuration.
 
Thanks to [http://vrhome.net/vassilis/ Vassilis] for developing and testing the code.

Latest revision as of 03:46, 18 December 2011

Redirect to:

Retrieved from "http://wiki.paparazziuav.org/w/index.php?title=Airspeed_sensor&oldid=11107"