Difference between revisions of "STLink"

From PaparazziUAV
Jump to navigation Jump to search
Line 45: Line 45:
If a complete STM32F-Discovery board is used, CN3 jumpers need to be set. To program a external MCU, remove CN3 jumpers and connect the external MCU with the SWD header.
If a complete STM32F-Discovery board is used, CN3 jumpers need to be set. To program a external MCU, remove CN3 jumpers and connect the external MCU with the SWD header.


To use SWD<br/>
To use STLink via SWD<br/>
Set '''FLASH_MODE=SWD'''<br/>
Set '''FLASH_MODE=STLINK'''<br/>
To use stlink (requires line above)<br/>
Set '''STLINK=y'''<br/>


==Update the ST-Link to blackmagic probe==
==Update the ST-Link to blackmagic probe==

Revision as of 12:15, 3 March 2014

St-link.jpg


SWD is a program und debug protocoll for ARM processors.

Every STM discovery board comes with a ST-LinkV2 on board (except STM32VL comes with ST-LinkV1).

Every dicovery board from STM comes wih a ST-LinkV2, except STM32VL (ST-LinkV1).

SWD Header

Pinout with Apogee connector

Install Software

st-flash and st-util are needed Tools from texane

download and compile

git clone git://github.com/texane/stlink.git stlink
cd stlink
./autogen.sh
./configure
make

copy the two tools into bin directory

sudo cp st-flash /usr/bin
sudo cp st-util /usr/bin

add udev rules (replace user with your username)

sudo cp /home/user/stlink/49-stlinkv*.rules /etc/udev/rules.d
sudo udevadm control --reload-rules

ST-LinkV1 requires a bit different treatment, read the Readme.txt


Airframe.xml setup

Connect the ST-Link to the MCU. If a complete STM32F-Discovery board is used, CN3 jumpers need to be set. To program a external MCU, remove CN3 jumpers and connect the external MCU with the SWD header.

To use STLink via SWD
Set FLASH_MODE=STLINK

Update the ST-Link to blackmagic probe

The STM32F103 (STLink MCU) can be flashed with the blackmagic's firware.
This is irveversable !

How to upload the blackmagic probe firmware to the STLink of a discovery board