Sensors

From PaparazziUAV
Jump to navigation Jump to search

Infrared Sensors

Paparazzi x-y IR sensor board

The paparazzi autopilot uses infrared thermopiles for primary attitude sensing. The theory is that at zero bank or pitch angle, the difference in the heat between the two sensors should be zero, and at 90 degrees it should be maximum. From this relationship a linear regression is made and angles are calculated during flight. Each pair of sensors measures one axis, a minimum of 2 pairs must be used to measure pitch and roll but best results are obtained thru the use of a 3rd pair on the vertical axis. Since the output signal from each sensor pair is proportional to both the attitude and the weather/terrain, systems with only x-y sensors require a ground calibration and may not provide accurate angle calculations as the aircraft travels over terrain with different IR radiation.

Architecture

IR Sensor Board Architecture.jpg

Dual Axis Board Pinout

Component Side View


Single Axis Board Pinout

Component Side View


Inertial Measurement

Work is underway to create a complete 17 state Kalman filtered inertial navigation solution! Watch the demonstration video of the current 7-state system.

Complete IMU head with 3-axis gyro, 3-axis accelerometer, and 3-axis magnetometer