Difference between revisions of "STLink"

From PaparazziUAV
Jump to: navigation, search
m (changed image of the swd header)
(Update the ST-Link to blackmagic probe)
Line 51: Line 51:
  
 
The STM32F103 (STLink MCU) can be flashed with the blackmagic's firware.<br/>
 
The STM32F103 (STLink MCU) can be flashed with the blackmagic's firware.<br/>
This is irveversable !
+
This is irrveversable !
  
[http://embdev.net/articles/STM_Discovery_as_Black_Magic_Probe How to upload the blackmagic probe firmware to the STLink of a discovery board]
+
[http://esden.net/2014/12/29/black-magic-discovery Black Magic Discovery from Esden] <-- This also describes how to remove the read out protection. <br/>
 +
[http://embdev.net/articles/STM_Discovery_as_Black_Magic_Probe embdev.net page]
  
 
[[Category:Firmware Flashing]] [[Category:Developer_Documentation]]
 
[[Category:Firmware Flashing]] [[Category:Developer_Documentation]]

Revision as of 10:19, 29 March 2015

St-link.jpg


Serial Wire Debug (SWD) is a program and debug protocol for ARM processors. It's a low pin count and high-performance alternative to JTAG

Every STM discovery board comes with a ST-Link V2 on board, with one exception; the STM32VL version, that board comes with ST-Link V1.

SWD Header

Pinout with Apogee connector

Install Software

The st-flash and st-util tools are needed, provied by texane

Download and compile

$ cd /opt
$ git clone git://github.com/texane/stlink.git stlink
$ cd stlink
$ ./autogen.sh
$ ./configure
$ make

Set enviroment variable

$ exportline="PATH=$PATH:/opt/stlink"
$ if grep -Fxq "$exportline" ~/.profile; then echo nothing to do ; else echo $exportline >> ~/.profile; fi
$ source ~/.profile

Add udev rules

$ sudo cp /opt/stlink/49-stlinkv*.rules /etc/udev/rules.d
$ sudo udevadm control --reload-rules

ST-LinkV1 requires a bit different treatment, read the Readme.txt

Airframe.xml setup

Connect the ST-Link to the MCU. If a complete STM32Fx-Discovery board is used, CN3 jumpers need to be set. To program a external MCU, remove CN3 jumpers and connect the external MCU with the SWD header.

To use SWD via STLink as default:
Set FLASH_MODE=STLINK

Update the ST-Link to blackmagic probe

The STM32F103 (STLink MCU) can be flashed with the blackmagic's firware.
This is irrveversable !

Black Magic Discovery from Esden <-- This also describes how to remove the read out protection.
embdev.net page