From PaparazziUAV
Revision as of 13:50, 8 January 2010 by Gany (talk | contribs) (TODO)

Jump to: navigation, search

Lisa ( the Lost Illusions Serendipitous Autopilot) is a STM32/Overo board designed to run Paparazzi


JTAG on STM32: ok

I2C on STM32:

SPI on STM32:

Pressure sensors:

USB for gumstix : does 5V need to be switchable ? (to allow reset from the gumstix)

Check FT2232 footprint:

Make sure STM32 can interrupt overo


- Todo's from sheet 3

- Check's from sheet 5

- Pressure sensor instruction to gany, so he can finish the schematic for that (or finish it directly in the schematic)

- Take todo's from above associate to names


- STM32 spelling and connection check

- howto for STM32 gcc gdb toolchain (blinking LED or similar)


- Place components

- Route board

- Send for production


The hardware is still in development. The current CAD files are maintained in savannah svn in the paparazzi4/trunk/hw/lisa directory. Software development is done on a Overo/Summit + Olimex STM32-H103 dev board

Lisa proto.jpg


STM32 toolchain

You can use the summon-arm-toolchain script to build the required toolchain. For the default values of the Paparazzi Makefile to work, you should set

PREFIX=/opt/stm32/toolchain/arm-elf and LIBSTM32_EN=1

Open Embedded

Open Embedded is the linux distribution used on the overo. You can follow the instructions on gumstix's website to build a complete cross development environment. Paparazzi's Makefile will default to look for it in /overo-oe