Infrared Sensors

From PaparazziUAV
Revision as of 18:38, 13 March 2011 by Rufus (talk | contribs)
Jump to navigation Jump to search


Favicon32.png Infrared Sensors

Hardware support for previous, currently in use and future infrared boards.

Hardware:

* Infrared_Double_Small_Sensor_Board

Infrared Stabilization Principle

The paparazzi autopilot uses infrared thermopiles for primary attitude sensing. The theory is that at zero bank or pitch angle, the difference in the heat between the two sensors should be zero, and at 90 degrees it should be maximum. From this relationship a linear regression is made and angles are calculated during flight.

Two axis infrared attitude measurement

Each pair of sensors measures one axis, a minimum of 2 pairs must be used to measure pitch and roll but best results are obtained thru the use of a 3rd pair on the vertical axis. Since the output signal from each sensor pair is proportional to both the attitude and the weather/terrain, systems with only x-y sensors require a ground calibration and may not provide accurate angle calculations as the aircraft travels over terrain with different IR radiation.

Three axis infrared attitude measurement

Hardware Architecture

Horizontal Board

IR Sensor Board Architecture dual.jpg

Vertical Board

IR Sensor Board Architecture single.jpg


Thermopiles

The Thermopiles are:

Manufacturer Part Number: MLX90247-ESF-DSA (Digi-Key)

Description: IC SENS THERMOPILE W/THERM TO-39