Classix

From PaparazziUAV
Revision as of 14:58, 7 December 2006 by Jeremy (talk | contribs)

Jump to: navigation, search

Classix Control Board

The Classix autopilot was designed for heavy sensing applications.

attachment:classix_proto1_top_small.jpg attachment:classix_proto1_bot_small.jpg

Features

  • Dual LPC2148 MCUs
  • 14 ADC channels
  • 2 UARTs
  • 6 PWM outputs
  • 2 RC Receivers inputs
  • 2 combined USB clients
  • 2 combined SPI
  • 2 I2C
  • Connector to dock with a Gumstix board
  • 3.3V linear regulator & 3.7V linear regulator (for Gumstix)
  • audio (for downlink)
  • 2 LEDs (status display)
  • 12 grams
  • 89 x 30mm

The Classix Control Board use 2 Philips LPC2148 ARM7 based microcontroller. The ARM7 is a low-power 32-bit RISC processor core and the Philips LPC2148 has 512KB on-chip Flash ROM, 40KB RAM and can be clocked at 60MHz.

With 2 MCUs this system is very robust, 1 MCU can handle all critical code, fly-by-wire and such, and the other can handle all autonomous processing. In the case of autonomous code error, the aircraft may be saved via manual control and the fbw MCU.

The ability to dock with a Gumstix board would allow for image processing, heavy communications, or payload support.

Architecture

Classix Architecture.jpg

Pinout

Classix v099 pinout.jpg

BOM

under construction