CrazybeeF4Pro
Crazybee F4 Pro
About
The Crazybee F4 Pro Flightcontroller is a redesign of a common F4 FC. There are different models with an embedded as the radio receiver. The Crazybee F4 Pro has embedded four ESC's to drive 4x brushless motors as commonly found on small raceing quadcopters like the
Specifications
PH2.0 battery connector
Variations
The Flightcontroller exists in four different PCB variations
- CrazyBeeF4FRPro for use with Frsky
- CrazyBeeF4DXPro for use with Spektrum
- CrazyBeeF4Pro Without receiver
- CrazyBeeF4FSPro with Nordic chip for Flysky
Versions
There are different versions of almost the same board V1,V2, V2.1 and V3. The differences in the table below:
Issues
Spiking power on the board when plugging in a 2s battery could lead to a broken board on the original design. To preven this from happening as add a capacitor to the battery lead. This capacitor should have an ESR lower than 0.2ohm and have a capacitance of 100uF or higher. A Rubycon ZLG/ZLH series and Samyoung NXB series.
Connect additional devices
Telemetry
Wifi Module
JeVois camera
Binding
To bind with your TX follow these steps
1. Connect battery 1. Pres an hold the bind button for about 2 seconds until the LED lits continuous 1. Enter the bind mode via your transmitter menu or bind button 1. The LED starts blinking as soon as binding was successful 1. Unpower battery, repower, start flying
Suppliers
One can buy one here:
More
This wiki is not the only place to get some info about the Hardware since the board can also be used for other flight stacks.
Airframe
An airframe using this board is:
- OpenUAS Trashcan