Difference between revisions of "User/AirborneCodeReorg"
Jump to navigation
Jump to search
(added available subsystems) |
|||
| Line 24: | Line 24: | ||
|- | |- | ||
|radio_control || spektrum || FW || spektrum based R/C input | |radio_control || spektrum || FW || spektrum based R/C input | ||
|- | |||
|telemetry || transparent || FW, rotor || to be used with any serial link replacement | |||
|- | |||
|telemetry || xbee_api || FW, rotor || for XBee modems in API mode | |||
|- | |||
|actuators || 4015 || FW || ? | |||
|- | |||
|actuators || 4017 || FW || ? | |||
|- | |||
|attitude || infrared || FW || | |||
|- | |||
|gps|| ublox_lea5h || FW || | |||
|- | |||
|gps|| ublox_lea4p || FW || | |||
|} | |} | ||
Revision as of 15:22, 17 August 2010
This page summarizes the changes needed to switch from the all "raw makefile in airframes" to a new "xml only aiframes" syntax
First step
- fixed wings users:
Comment out or remove the following lines in the makefile section of your airframe.xml
ap.CFLAGS += -DRADIO_CONTROL ap.srcs += radio_control.c $(SRC_ARCH)/ppm_hw.c
Add a new xml section like this:
<target name="fixed_wings" board="tiny_2.11"> <subsystem name="radio_control" type="ppm"/> </target>
you can look in conf/airframes/microjet5.xml to see how it's done. The list of supported boards is "twog_1", "tiny_2.11", "tiny_2.1", "tiny_1.1", "tiny_0.99", "booz" and "lisa_l_1.0"
available subsystems
| Name | type | airframe(s) | description |
|---|---|---|---|
| radio_control | ppm | FW | ppm based R/C input |
| radio_control | spektrum | FW | spektrum based R/C input |
| telemetry | transparent | FW, rotor | to be used with any serial link replacement |
| telemetry | xbee_api | FW, rotor | for XBee modems in API mode |
| actuators | 4015 | FW | ? |
| actuators | 4017 | FW | ? |
| attitude | infrared | FW | |
| gps | ublox_lea5h | FW | |
| gps | ublox_lea4p | FW |