Twog v1

From PaparazziUAV
Jump to navigation Jump to search


 !! WARNING !!

THIS IS A PRELIMINARY DESIGN, IT HAS NOT BEEN TESTED YET.
DO NOT USE FOR MASS PRODUCTION AS LONG AS THIS MESSAGE REMAIN.


Twog v1.00 3D top view

Hardware Revision History

Version # Release Date Release Notes
v1.00 04/2008 Initial release of Twog v1

Features

  • Single LPC2148 MCU
  • 8 x Analog input channels 0V - 3.3V (2 channels with optional on-board resistor bridge)
  • 1 x 3.3V TTL UART (5V tolerant)
  • 8 x PWM outputs
  • 1 x R/C receiver PPM frame input
  • 1 x SPI bus
  • 1 x I2C bus
  • 1 x USB (client)
  • 5V/2.5A switching power supply & 3.3V/1A linear regulator
  • 3 x status LEDs with attached test point
  • ?? grams
  • 40.2 x 30.5mm (1.6" x 1.2")
  • 2 layers PCB design, 0603 components

Architecture

Pinout

Pins Name and Type are specified with respect to the Autopilot Board

Schematic

Twog v1.00 Schematic


PCB

Gerber & Drill Files

Download Twog v1.00 gerber & drill files (zip)

RS274X, units = Inches, format = 2:5

  • Twog_v1-00.GTO (Top Component Print Layer)
  • Twog_v1-00.GTS (Top Solder Mask)
  • Twog_v1-00.GTL (Top Copper Layer)
  • Twog_v1-00.GBL (Bottom Copper Layer)
  • Twog_v1-00.GBS (Bottom Solder Mask)
  • Twog_v1-00.DRI (NC XY coordinates & Drill tools sizes)

Possible PCB Manufacturers

Assembly

Components Layout

Bill Of Material

Download Twog v1.00 Bill Of Material (zipped .xls file)

Downloads

Source files

Gerber & Drill files

Assembly files