Difference between revisions of "Tunnel"
Jump to navigation
Jump to search
| Line 9: | Line 9: | ||
<li>Connect 8-pin Molex Connector on the Adapter cable to "usb" on Tiny2.11 | <li>Connect 8-pin Molex Connector on the Adapter cable to "usb" on Tiny2.11 | ||
<li>Power on Tiny2.11 | <li>Power on Tiny2.11 | ||
<li>Enter this command in a terminal: make | <li>Enter this command in a terminal: make AIRCRAFT=ppz1 tunnel.upload | ||
</ol> | </ol> | ||
<p>Success will show this in the last lines of the terminal window</p> | <p>Success will show this in the last lines of the terminal window</p> | ||
Revision as of 12:03, 23 April 2008
Required Cables:
- USB cable
- USB to 8-pin Molex Picoblade connector adapter cable
Steps:
- Connect USB Cable + 8-pin Molex adapter to USB on your laptop
- Connect 8-pin Molex Connector on the Adapter cable to "usb" on Tiny2.11
- Power on Tiny2.11
- Enter this command in a terminal: make AIRCRAFT=ppz1 tunnel.upload
Success will show this in the last lines of the terminal window
Found USB device BootROM code: 2.12 Part ID: 0x0402FF25 (LPC2148, 512k Flash, 32k+8k RAM) BootLoader version: 1.3 # Starting software at 0x00004000