Difference between revisions of "Tiny GPS config"

Revision as of 19:33, 20 April 2008

Prerequisites:

Required Cables:

Steps:

Connect FTDI cable + 8-pin Molex adapter to USB on your laptop
Connect 8-pin Molex to "serial1" on Tiny2.11
Power on Tiny2.11
Start u-center application
set connection speed to 9600BPS (LEA-4P factory default)
Menu: Tools/GPS Config select the file to upload (LEA-4P file downloaded)
Click File >> GPS button to send the file to the GPS
About 2/3 the way through it will stop. At this point change 'baudrate' to 38,4000 connection and it will continue and finish

@@ Line 3: / Line 3: @@
 <li>Must have loaded USB Boot Loader software
 <li>Must have loaded "tunnel"
+<li>Must have downloaded and installed u-center
+<li>Must have downloaded, uncompressed the LEA-4P config file
 </ol>
 Required Cables:
@@ Line 13: / Line 15: @@
 <li>Connect FTDI cable + 8-pin Molex adapter to USB on your laptop
 <li>Connect 8-pin Molex to "serial1" on Tiny2.11
-<li>Using "Jumper" set P0.14 "low" and keep it held low
 <li>Power on Tiny2.11
-<li>Enter this command in a terminal: make upload_bl PROC=GENERIC
+<li>Start u-center application
+<li>set connection speed to 9600BPS (LEA-4P factory default)
+<li>Menu: Tools/GPS Config select the file to upload (LEA-4P file downloaded)
+<li>Click File >> GPS button to send the file to the GPS
+<li>About 2/3 the way through it will stop. At this point change 'baudrate' to 38,4000 connection and it will continue and finish
 </ol>
 [http://paparazzi.enac.fr/wiki/index.php/Tiny_v2#Programming BACK]