Difference between revisions of "SDLogger SPI Direct"

From PaparazziUAV
Jump to: navigation, search
(Page creation)
 
m
Line 1: Line 1:
 
The direct SPI SD Logger is originally designed to be used with the Lisa/S, but should also be compatible with other supported autopilots. It connects directly to the SPI bus of the autopilot and communicates using the SDCards SPI interface. This method is slower than when using it in SD mode, but the speed is sufficient to log IMU data at 512 Hz.
 
The direct SPI SD Logger is originally designed to be used with the Lisa/S, but should also be compatible with other supported autopilots. It connects directly to the SPI bus of the autopilot and communicates using the SDCards SPI interface. This method is slower than when using it in SD mode, but the speed is sufficient to log IMU data at 512 Hz.
  
[[File:LisaSD|thumbnail|Lisa/SD module]]
+
[[File:LisaSD.jpeg|thumbnail|Lisa/SD module]]
  
 
== Installation ==
 
== Installation ==
  
 
=== Lisa/SD ===
 
=== Lisa/SD ===
 +
A SuperbitRF-sized PCB connects the SD card to the Lisa/S. Additionally, this PCB has pads to connect a Deltang R31d RC receiver and a molex connector for general purpose.
 +
 +
[[File:LisaSDback.jpeg|thumbnail|Lisa/SD module with Deltang R31d]]

Revision as of 14:49, 10 November 2015

The direct SPI SD Logger is originally designed to be used with the Lisa/S, but should also be compatible with other supported autopilots. It connects directly to the SPI bus of the autopilot and communicates using the SDCards SPI interface. This method is slower than when using it in SD mode, but the speed is sufficient to log IMU data at 512 Hz.

Lisa/SD module

Installation

Lisa/SD

A SuperbitRF-sized PCB connects the SD card to the Lisa/S. Additionally, this PCB has pads to connect a Deltang R31d RC receiver and a molex connector for general purpose.

Lisa/SD module with Deltang R31d