Difference between revisions of "Rolling Spider"

From PaparazziUAV
Jump to: navigation, search
(Connect with Bluetooth)
(Replaced content with "#REDIRECT Ap.parrot_minidrone")
(7 intermediate revisions by 3 users not shown)
Line 1: Line 1:
<div style="float: right; width: 15%"><categorytree style="float:right; clear:right; margin-left:1ex; border: 1px solid gray; padding: 0.7ex;" mode=pages>Autopilots</categorytree></div>
#REDIRECT [[Ap.parrot_minidrone]]
<div style="float: right; width: 45%; overflow: hidden">[[Image:RS_BLUE_FrontView_Wheels_Sticker.jpeg|right|500px|Parrot Rolling Spider]]</div>
<div style="float: right; width: 40%">__TOC__</div>
== Intro ==
Originally the [http://www.parrot.com/usa/products/rolling-spider/ Rolling Spider] from [http://www.parrot.com/ Parrot] is a Bluetooth controlled flying quadrotor, designed to be controlled with an Android or iOS device.
Not any more: With a few simple clicks you can run Paparazzi on the Bebop and have full autonomous flight and much more!
== Features ==
=== Connectivity ===
* Bluetooth Smart technology, Bluetooth V4.0 BLE (Bluetooth Low Energy).
* Normal bluetooth also possible
=== Sensors ===
* Ultrasonic sensor
* 3-axis gyroscope and 3-axis accelerometer (MPU 6050)
* Vertical camera
* Pressure sensor
=== Battery ===
Lithium-Polymer and removable
Lasts up 8 min (6 min with wheels) and full recharge in 90 min
=== Weight / Dimensions ===
* 55g (65g with wheels)
* Rolling Spider diameter: 140 mm
* Propellers' diameter: 55mm
* Motor spacing: 85 mm
== How to connect ==
There are two ways to connect to the Rolling Spider with Paparazzi. The first one is an USB cable and the second one is Bluetooth (4.0 or normal). Both have the possibility to connect as WiFi access point and transfer files through FTP and execute programs over telnet. But be warned that connecting over USB disables the vertical camera, as it uses the same USB bus.
=== Connect with USB ===
* Set the Rolling spider on
* Just plug in a micro-usb cable from your drone to the computer
* A new network device will show up
* Connect with '''''' through ftp or telnet
=== Connect with Bluetooth ===
* Turn the rolling spider on
* Make sure you have bluetooth enabled on your computer
* Execute "hcitool scan" and look for the mac address of the "RS_...." device. (If you cannot find it look at [[#Setup normal Bluetooth]])
* Install the bluez-utils package (if not installed) with "sudo apt-get install bluez-utils"
* Execute "sudo pand --connect <MAC address> -dGN -n", to connect to the bluetooth of the drone. *
* Execute "sudo ifconfig bnep0 up", to setup the ethernet device over bluetooth. *
* Connect with '''''' through ftp or telnet
<nowiki>*</nowiki> This has to be done everytime you reboot the drone
=== Setup normal Bluetooth ===
* First connect over Bluetooth 4.0 or USB to the drone as described above
* Connect with telnet to the drone. (telnet 192.168.*.1)
* Open the "/etc/init.d/rcS" file and search for the line with "BLEproxy". (vi /etc/init.d/rcS)
* Now change the "BLEproxy" to "BLEproxy --normalbt"
* Reboot your drone by executing: "reboot". (This makes sure the filesystem is saved)

Latest revision as of 03:55, 19 July 2017