Difference between revisions of "DevGuide/BoozDesign"
From PaparazziUAV
m |
|||
| Line 26: | Line 26: | ||
possible priority systems: | possible priority systems: | ||
| − | #Every mode belongs to a certain priority level. If an event requests a new mode with a higher priority than the current mode it is switched to the new mode. | + | #Every mode belongs to a certain priority level. If an event requests a new mode with a higher priority than the current mode it is switched to the new mode.<br>Better suited for a lot of different modes which can be grouped into priority levels. |
| − | + | #Every event has a condition (current mode) and associated requested mode (or multiple conditions). If the condition matches the current mode the autopilot will switch to the new mode.<br>e.g. '''Event:''' GPS lost '''Condition:''' Nav mode '''ReqMode:''' Failsafe<br>This will get tedious with a lot of modes.... | |
| − | #Every event has a condition (current mode) and associated requested mode (or multiple conditions). If the condition matches the current mode the autopilot will switch to the new mode.<br> | ||
| − | |||
| − | |||
== Current Status == | == Current Status == | ||
Revision as of 09:04, 21 September 2009
Here we want to collect our thoughts on the re-design of the booz airborne code.
Use Cases
- Interface on Navigation, Guidance, Stabilization and Supervision level
- Priority system
- priority of RC to switch to manual
- Overlay of different inputs
- RC over Guidance
- FMS over RC (e.g. test signal)
- Limit max. throttle with RC
Requirements
Autopilot
Describe modules (nav, guidance, stabilization, etc.) as xml with in and outputs. A mode is a specific connection of modules. Events can change the mode.
Events:
- Mode change from RC
- RC lost
- GPS lost
- outside zone
- battery low
possible priority systems:
- Every mode belongs to a certain priority level. If an event requests a new mode with a higher priority than the current mode it is switched to the new mode.
Better suited for a lot of different modes which can be grouped into priority levels. - Every event has a condition (current mode) and associated requested mode (or multiple conditions). If the condition matches the current mode the autopilot will switch to the new mode.
e.g. Event: GPS lost Condition: Nav mode ReqMode: Failsafe
This will get tedious with a lot of modes....
Current Status
The ImageMap extension is not installed.
ReDesign
input and control loops
The ImageMap extension is not installed.
