View source for ATmega328 PPM Encoder Board

<p>Thanks to Chris we have a way to use virtually any RC receiver with Paparazzi without any modifications to the receiver.</p>
<p>This board plugs into the servo output ports on a R/C receiver and encodes them into a single PPM pulse suitable for the paparazzi autopilot. It is also possible to remap channels by changing the connection between the receiver and the encoder. Want Tx ch5 to be output on ch7 of the ppm stream? Just connect the Ch5 signal from the receiver to the Ch7 input on the encoder.</p>
[[Image:Ppmencv3_sm.jpg|250px]]

Note: see the [[ATmega168_PPM_Encoder_Board]] page for the more recent hardware version. Wiki refactor in progress, these pages will be merged.

= Programming the PPM encoder =
<p>Programming the board can easily be accomplished using an AVR ISP (in-serial programming) programmer.  These are inexpensive and can be found many places online.  Once you have the ISP connected to the PPM encoder, simply use avrdude with the following command:</p>

For ATmega168:

<code>avrdude -p atmega168 -P <Insert port here> -c <Insert ISP type here> -U lfuse:w:0b00100010:m -U efuse:w:0b111:m -U flash:w:servo2ppm+bootloader.hex</code>

Fuse settings shown above may give unpredictable results and strange behaviour, depending on device and crystal.

So the better settings are:

<code>avrdude -p atmega168 -P <Insert port here> -c <Insert ISP type here> -U lfuse:w:0b11110111:m -U efuse:w:0b111:m hfuse:w:0b11011001:m -U flash:w:servo2ppm+bootloader.hex</code>

For ATmega328P set the fuse bytes as shown next:

<code>avrdude -p m328p -P <Insert port here> -c <Insert ISP type here> -U lfuse:w:0b11110111:m -U efuse:w:0b111:m hfuse:w:0b11011001:m -U flash:w:ppm_encoder_v4_3+bootloader_16Mhz.hex</code>

If you use 328P and a PonyProg-Cable for COM or a Mikrokopter SerCon, type the following: (replace COM1 with actual COM-port):

<code>avrdude -p m328p -P COM1 -c ponyser -U lfuse:w:0b11110111:m -U efuse:w:0b111:m hfuse:w:0b11011001:m -U flash:w:ppm_encoder_v4_3+bootloader_16Mhz.hex</code>
-----
'''Source files'''
:*Link to firmware file: ''[[http://www.rcgroups.com/forums/showpost.php?p=14347844&postcount=2445 PPM Encoder Eagle and latest (4.3 Feb 2010) firmware (zip)]]''
'''Gerber & Drill files'''
:*download "[[Media:Eagle_pcb.zip|PPM Encoder Eagle design files 4.3(zip)]]"
:*download ''[[Media:Gerber_for_PPM_Encoder.zip|PPM Encoder gerber & drill files (zip)]]''
:*download "[[Media:Servo2ppm_manual_v4_2.pdf|PPM Encoder manual (PDF)]]"